PDAStreet: Message Boards: Zaurus: Re: Re: Help! I need help to build a Link Cable for my old ZR-5700.

PDAStreet.com: Message Boards: Zaurus: Re: Re: Help! I need help to build a Link Cable for my old ZR-5700.

Re: Re: Help! I need help to build a Link Cable for my old ZR-5700.

You are looking at Message Board Archives!
Please access our new message boards at http://www.pdastreet.com/forums/ .

Post Reply | Read Replies | Start New Thread | Zaurus Board Index

Zaurus Board (Del Msg)

Title: Re: Re: Help! I need help to build a Link Cable for my old ZR-5700. In Reply To

Posted By: Cristian Title: Re: Help! I need help to build a Link Cable for my old ZR-5700.

E-mail: cristilo@pcnet.ro Posted By: Jake

Date: 10/17/2001 at 02:55:52 Date: 10/17/2001

Message:
Thanks for the info. I have already a printout of the circuit, but I cannot understand the difference between the RS232 and MAX232. There is a nine V source, and some other components. In my cable there are only three wires and I think that there are corresponding to RX, TX and GND. It is possible to establish a communication only with these.

Is this message offensive or in violation of this board's policies? If so report it by clicking here.