Strange Digitizer problem.

[Peregrine]

I suffer from a strange m100 digitizer problem, which no third party utilities or palm tech suppor has been able to solve.

Instead of setting where I touch to the center of each target, it rejects touches on the center and requires touches to be offset by several pixels, normally up and to the left or down and to the right (for upper left and lower right targets respectively)
This makes the final calibration wrong by as much as 1 cm, and that makes it impossible to touch many menus. Does anyone know:
A) If there is a solution to this problem.
B) If anyone else has had this problem.
C) Anything speciall I'd need to know if I coded my own digitizer.

[Telyx]

m100s are known for digitizer problems, usually in the lower left quadrant of the screen. It's a hardware problem. There are a few digitizer re-calibration programs like AutoDigi and Digifix, but they assume you can get a good calibration to start with.

I would suggest returning the unit and getting a new one (or a m105/m125, maybe).