jsmiley999
10-01-2002, 01:04 PM
I have been using Avantage in order to have Avantgo run on my expansion card. This allows me to not use up so much of the main memory. Anyway, when I hotsync, everything works and all the information comes over. However, every other time I hotsync, the m505 says "Cleaning up - please wait". I wait and wait and wait and.....It freezes in this state. All I can do is a soft reset. Does anyone else out there have this problem? I don't know if it's good for the 505 to be resetting frequently. In fact, sometimes, a hard reset is needed to bring it back, although not very often. As I said, the above happens every other time with regularity. The other times, it works fine after cleaning up. Any ideas??
:)
:)