Help! Installation reset

[rjack22]

I am in the process of installing my new iQue. I am to the last step. I have done the HotSync and the system has detected the new hardware. I proceeded thru the steps in the New Hardware Wizard. Then the instructions say that after this HotSync operation is complete, the iQue will beep. It did. Now here is the rub. It says to "tap 'reset' on the iQue screen to continue. The iQue will power off and restart.

Well I for the life of me cannot fine anything named Reset, much less tap it and restart.

Can anyone help me? Garmin support is not available until Monday morning!

HELP!

[jonasolof]

Then you need to do a soft reset using the unscrewed tip of your stylus and push the thin end through the little hole named reset at the back of the ique.

[jshort]

Robin,

Going through initial install myself this morning. iQue will actually beep twice... at least, it did for me. Once when HotSync starts (or maybe its when the computer recognizes the iQue) and the second time is when its done. The second beep is when you should see a dialog box with Reset as one (only one?) of its choices.

If that doesn't work, then do a soft reset as suggested.

Jeff