Letter Recognizer not working properly?

[bacchus_3]

Hi,

This is the first time I encountered this on my IPAQ 2215. Ever since I had it in December Letter Recognizer works fine with me writing a 't' with 2 strokes, a '+', a colon ':' and a semicolon ';' (I'm sure there are other characters I would find difficulty writing again thatI haven't checked out yet).

Does anyone have the same experience? If you do, how did you revert it back to act the same? (My last resort is a hard reset so I'd like to know a software config change firstbefore doing this - it's a burden to reinstall and configure everything again).

Thanks

[Npitlor]

Have you gone through the steps of training it?

Did you change the angle setting?

Those are always two good starting points.

[bacchus_3]

I just found the culprit late this evening. It's a StartUp application CWTimeOut.exe from one of the apps I installed2 days ago. I'm still checking out what it is.