MacK
10-31-2002, 10:37 AM
I just purchased a refurbed SL-10 (on UBID) to upgrade from old S-300. I tried to beam my data across, but the SL-10 is not responding, and the s-300 times out in "searching" mode. I also tried to beam from the SL-10 and the s300 responded with "waiting for sender" but the Sl-10 never did change from "searching" mode, until it timed out. I made sure that the "Beam Recieve " was set to "on".
I tried a soft reset, but that did not solve the problem. I have two questions:
1. Does anyone have any other ideas on getting the SL-10 to beam?
2. How do I perform a hard reset on the SL-10?
Thanks, The Big Mack...:confused:
I tried a soft reset, but that did not solve the problem. I have two questions:
1. Does anyone have any other ideas on getting the SL-10 to beam?
2. How do I perform a hard reset on the SL-10?
Thanks, The Big Mack...:confused: