Pelaca
11-12-2002, 03:36 AM
I found a problem on the Zire... and I want share the knowledge...
Well... Today I start my instalation of the Palm Desktop... but for my suprise the Zire was not recognized for my XP (the Zire claims to be charger connected, not wall charger connected, only USB cable)... I try a lot of thinks... I reinstall a lot of times the drivers... I try in win2K and XP too... I check the voltage in the USB chip, all are OK but doesn´t works... 4 hours later I found a bad contact betwen the MiniUSB cable and the MiniUSB conector on the Zire... fucking small conectors... If that the case you have to use a electronic longnose plier, or similar, for close a little the MiniUSB conector on the middle (male conector, don´t press too much) and works again...
I use this Plier
http://www.xuron.com/consumer/pliers/485.jpg
I close a little this connector...
http://www.panintl.com/img/Mini-5pin.gif
I hope this helps if you´ve the same problem...
Well... Today I start my instalation of the Palm Desktop... but for my suprise the Zire was not recognized for my XP (the Zire claims to be charger connected, not wall charger connected, only USB cable)... I try a lot of thinks... I reinstall a lot of times the drivers... I try in win2K and XP too... I check the voltage in the USB chip, all are OK but doesn´t works... 4 hours later I found a bad contact betwen the MiniUSB cable and the MiniUSB conector on the Zire... fucking small conectors... If that the case you have to use a electronic longnose plier, or similar, for close a little the MiniUSB conector on the middle (male conector, don´t press too much) and works again...
I use this Plier
http://www.xuron.com/consumer/pliers/485.jpg
I close a little this connector...
http://www.panintl.com/img/Mini-5pin.gif
I hope this helps if you´ve the same problem...