Saved routes - utl_assert.c

[Division]

Clicking on "saved routes" on my IQue 3600, I receive (every time) the following error message:

"utl_assert.c, Line:382,
Assert failed at \udb_srte.c
: 3973 in UI Thread"

The only thing I can then do is push a reset button that is displayed below the message.
The error message occured for the first time when erasing a "faulty" route, which was wrongly displayed on the map. Thus there was something wrong before.

But anyway, I tried to so a hard reset (Power on button pushed when resetting), answered "yes" to erase everything, but the error remains.

Having a look at the hot sync, I noticed that I cannot access the routes from Palm Desktop. Any hints? Many thanks in advance!

[HighFive]

Hi,

I've had this error too (once). The only way to get rid of it, is to use Garmin's NonVolUtil.PRC to erase (parts of) the iQue's non-volatile memory.

Instead of asking Garmin, you might want to download it here (http://homepage.hispeed.ch/smilespergallon/nonvolutil.html).

I think it is sufficient to delete the "UDB Saved Routes" in the list shown by NonVolUtil. The bad news is that all your routes will be gone.

Good luck,
HighFive

[Division]

Thanks a lot, I will have a try!

But where are my routes are backed up? I thought there might some place on my laptop which is updated during hotsync. I downloaded Track Conduit for example to back up the tracks. Is there any known solution for the rest of the data (waypoints etc.)?

[HighFive]

Hi Division,

Your answer can be found here (http://homepage.hispeed.ch/smilespergallon/ique/redirect001.html)

Cheers,
H5

[Division]

Unfortunately, when I start NonVolUtil, I get the following message:

"NonVolUtil.cpp, Line:546,
Can´t open NonVolLib"

Then I have to reset. Any hints?

[HighFive]

Then I have to reset. Any hints?

Yes, look here (http://homepage.hispeed.ch/smilespergallon/ique/redirect002.html)

H5